Valve Setup - Pro-Aqua PRO-S-80E Owner's Manual

VALVE SETUP

IMPORTANT!
!
Locate and test the main water supply valve to the home before installing the system. If the main water
supply valve fails to shut off the water completely during the test, we recommend contacting a licensed
plumber to fix the valve before begin installing the system.
WARNING!
If the system is installed on a metal (Conductive) plumbing system, i.e.. copper or galvanized metal, the
plastic components of the system will interrupt the continuity of the plumbing system. As a result, any
arrant electricity from improperly grounded appliances downstream or potential galvanic activity in the
plumbing system can no longer ground through contiguous metal plumbing. Some homes may have
been built in accordance with building codes, which actually encouraged the grounding of electrical
appliances through plumbing. A grounded "jumper wire" bridging the equipment and reestablishing the
contiguous conductive nature of the plumbing system must be installed prior to your system use.
WARNING!
Electric Hot Water Tanks: Turn off the power to the unit first to avoid damage.
Well Water: Power off the well water pump and then shut off the main water supply valve.
Shut Off Main Water Supply
1
1. Locate the main water supply valve to the house and completely turn off by turning the handle
clockwise.
2. Test to see if the water is completely shut off by turning on the cold water on the closest faucet. If the
cold water cannot be shut off, please contact your local plumber to fix the valve before installing the
system.
Bypass Valve Assembly & Installation
2
1. Lubricate the o-rings on the Bypass Valve
then attached the Yoke to the Bypass valve
by pressing the yoke onto the Bypass (both
sides of the ports at the same time).
2. Ensure to lubricate the o-rings to avoid any
leaks.
3. Attach the metal clips to both sides of the
Bypass Valve to hold the Yoke to the Bypass.
(Skip this step if the Yoke is already pre-
installed. )
- 6 -