Leveling & Height Adjustment - ACCO Brands GBC Ricoh StreamPunch Ultra Installation Manual

7. Leveling & Height Adjustment
7.1 Height Setting
No height adjustment of the StreamPunch Ultra/MP is required for an installation site with a level floor. If
the floor is uneven then it is recommended to set the level of the StreamPunch Ultra/MP using the upstream
device as a reference. . If the StreamPunch Ultra/MP is connected downstream of a printer with a decurler
installed then the documentation supplied with the decurler should be referred to set the decurler exit height.
After setting the height check the exit guide of the StreamPunch Ultra/MP is set as shown below for the
various finisher types.
Downstream
Device Input
Finisher
SR5050; SR5060;
SR4080; SR4110
SR4140; SR5110
SR5120; SR5040
7.2 Adjusting the Casters
a)
StreamPunch Ultra
Output
X
Reference Height X
3mm
Ricoh StreamPunch Ultra/MP Installation Manual
SK5040
Stacker
SK5040
Using a 19mm (3/4") open ended wrench, loosen
the jam nut(s) situated on the caster stud under
the base of the machine
Y
Reference Height Y
2.5mm
.
9