Cable Connections - ACCO Brands GBC Ricoh StreamPunch Ultra Installation Manual

6. Cable connections

Power OFF the entire system before making the connections.
It is important to turn OFF the main power switch inside the front door of the printer.
a) Cable Connections for Finisher or Stack: Unplug and remove the finisher (or) stacker rear cover and plug the
supplied communication cable to connector as shown below (see section 3. for which communication cable to
use):
i) CN109 when connecting to a SR5050, SR5060, SR5070, and SR5080 Finisher
ii) CN550 when connecting to a SK5040 stacker
CN144 when connecting to a SR4080 or SR4110 finisher.
iii)
CN144 is located near the bottom
left of the control board.
Ricoh StreamPunch Ultra/MP Installation Manual
CN109 is
located on
the left side
of the
Finisher's
control board
CN550 is
located near the
left top corner of
the Stacker's
control board
5