Table of Contents
Advertisement
Quick Links
San Diego, CA 92110 USA
www.ecr4kids.com
5 Section Coat Locker w/ Bench
Model# ELR-0453-B
WARNING:
Adult Assembly Required.
Two adults recommended.
- Contains small parts, sharp points and edges.
- Do not stand, sit, kneel, climb, lean or pull on unit for support.
- Never leave children unattended.
- Do not place unit near high heat or moisture.
- Adult supervision recommended.
Children climbing on furniture
can lead to death or serious
injury due to tipping. Secure
unit to wall using appropriate
hardware.
TOOLS INCLUDED
Hex Tool (1)
A
B
C
D
E
TOOLS NEEDED
Phillips Screwdriver
Parts List
BEFORE ASSEMBLING, MAKE SURE YOU HAVE ALL THE PARTS
Left & Right Side Panels (1/1)
A1
A2
Top Panel (1)
Upper Shelf (1)
Lower Shelf (1)
Bottom Shelf (1)
Batch ID Sticker
located on underside
F
Upper Dividers (4)
G
Upper Back Panel (5)
H
I
Lower Back Panel (1)
J
Cam Posts & Cam Locks (16/16)
K
K1
K2
Hanger Hook Posts
L
M
& Screws (12/12)
L1
L2
Use a Phillips Screwdriver
Lower Dividers (4)
Hex Screw (32)
Use the
Hex Tool
Use a Phillips
Screwdriver
Hanger Hooks (10)
Advertisement
Table of Contents
Related Manuals for ECR 4 Kids ELR-0453-B
Summary of Contents for ECR 4 Kids ELR-0453-B
- Page 1 San Diego, CA 92110 USA Left & Right Side Panels (1/1) Upper Dividers (4) Upper Back Panel (5) www.ecr4kids.com 5 Section Coat Locker w/ Bench Model# ELR-0453-B Lower Dividers (4) Top Panel (1) Lower Back Panel (1) WARNING: Adult Assembly Required.
- Page 2 Install Lower Dividers onto Bottom Shelf Connect Lower Dividers to Lower Shelf Install the four Lower Dividers (H) to the Bottom Shelf (E) with eight Hex Screws (J) Place two Cam Locks (K2) into the recessed holes on each Lower Dividers (H), with the using the Hex Tool.
- Page 3 Insert Upper Back Panels Insert the Left Upper Back Panel Slide three Upper Back Panels (G) Slide an Upper Back Panel (G) into the grooves on the Top Panel (B) and Lower Shelf (D) as into the grooves on the Upper shown, until fully seated into the groove on the side of the Upper Divider (F).
- Page 4 Insert the Remaining Back Panels Install the Coat Hooks Slide the remaining Upper Back Panel (G) into the grooves on the Top Panel (B) and Lower Install two Hanger Hooks (N) to each locker section by threading the Hanger Hook Posts & Shelf (D) as shown, until fully seated into the groove on the side of the Upper Divider (F).
- Page 5 Clean unit with a damp cloth or sponge Save this sheet in an accessible place. using warm water and mild soap. Wipe dry. Model Number: ELR-0453-B Do not place near heat, moisture or vaporizer which may cause panels to warp Factory Code: EP and peel.
Need help?
Do you have a question about the ELR-0453-B and is the answer not in the manual?
Questions and answers