Scantronic 601 User Manual

601/602 USER GUIDE
Leave by
designated
route
(
=
four digit user code
ENTER

TO OMIT A ZONE

OMIT
FOR OTHER
(
ZONES
OMIT
ZONE
NUMBER
ENTER

TO SWITCH OFF

Enter by
Go to
designated
panel
route

PANIC ALARM

Service Telephone No:

TO FULL SET

Key in your user code. The Armed light
flashes and the exit tone starts. Leave
the premises by the designated exit
route.
The exit tone stops after a preset time
and the Armed light glows steadily.
The alarm system is then set.
)

TO PART SET

To set your alarm system so that you
can move around part of the area nor-
mally covered by detectors:
Key in 2 + ENTER followed by your
security code. The Armed light flashes
slowly. Leave the protected area. After
a preset time the panel gives a double
bleep. The system is now part set.
Note: The installer may have disabled
the part set facility. Contact them if
you have any difficulty.
Key in your user code, followed by
OMIT and the zone number within five
seconds. The Armed light and the zone
ZONE
NUMBER
light to be omitted flash, and the exit
tone starts. Leave the premises. After a
)
pre-set time the exit tone stops and
the Armed light glows steadily. The
system is now set with an omitted
zone.

CHIME

Key in 7 + ENTER followed by your
user code. The panel gives a two tone
bleep. While chime is on, the panel
gives a two tone bleep every time a
detector is triggered. Note: The installer
may not have programmed every
detector to trigger a chime.
To switch Chime off: key in 7 + ENTER
followed by your user code.
Enter by the designated entry route.
The entry tone starts. Go to the control
panel and key in your four digit user
code. The Armed light goes out. The
system is unset.
Press 1 and 3 at the same time. The
panel does not give any indication of
an alarm.
Part No: 496181 Issue 1