Mount the unit to provide enough access for maintenance or repair operations.
The wall for mounting must have even surface. Any surface irregularities will lead to unit casing skew and may prevent the unit from operating properly. The minimum distances
from the unit to the mounting surfaces are shown in fig. 1.
Bodor Vents, LLC DBA: VENTS-US
11013 Kenwood Road Cincinnati, Ohio 45242
Phone: (513)348-3853
e-mail: sales@ventsus.com
www.ventsus.com
Drill 2 Ø 1⁄4"
Screwdriver
min 12'' mm
Fig. 1. Minimum distance from the unit to the surfaces
Page 1
1. min 12’’ mm min 12’’ mm Fig. 1. Minimum distance from the unit to the surfaces Bodor Vents, LLC DBA: VENTS-US 11013 Kenwood Road Cincinnati, Ohio 45242 Phone: (513)348-3853 MIU_54(MICRA_150)-01 e-mail: sales@ventsus.com...
Page 2
5. Insert the air ducts into the respective openings of the master plate. Bodor Vents, LLC DBA: VENTS-US 11013 Kenwood Road Cincinnati, Ohio 45242 Phone: (513)348-3853 MIU_54(MICRA_150)-01 e-mail: sales@ventsus.com...
Page 3
The circuit breaker trip current must be in compliance with the current consumption. The recommended circuit breaker rated current is 2.5 A. While selecting the automatic circuit breaker consider the maximum wire temperature that depends on the wire type, insulation, length and layout way (open wire mounting, channel type or wall-mounted). Bodor Vents, LLC DBA: VENTS-US 11013 Kenwood Road Cincinnati, Ohio 45242...
Page 4
UNIT ~ 120 V / 60 Hz Fig. 4. Power cable connection to terminal block Bodor Vents, LLC DBA: VENTS-US 11013 Kenwood Road Cincinnati, Ohio 45242 Phone: (513)348-3853 MIU_54(MICRA_150)-01 e-mail: sales@ventsus.com www.ventsus.com...