Align camera
The camera can be aligned in order to adapt the
camera picture to the local circumstances (Figure
14 and 15).
The door station is installed.
Loosen the locating screw for the camera 1.5
mm
with the Allen key supplied (Figure 13).
Call an indoor station video from the door stati-
on by call push-button.
Figure 13: Alignment of the camera
Align camera (fi gure 14/15).
The entrance area is clearly visible on the
display of the indoor station.
Fix camera again with screw (4).
1
2 m
2 m
1
0
1
2
Figure 14: Vertical camera orientation
2
1
0
1
2 m
2
1
Figure 15: Horizontal camera orientation
5
Dismantle call push-button module cover
During cleaning or replacement, the call push-but-
ton module cover can be dismantled from the front.
Lever up the interlocking cover strips (7) at
the top and bottom using the screwdriver and
remove (Figure 16).
(4)
Figure 16: Removal of cover strips
Press up the call push-button module cover in
the bottom lever opening with the screwdriver
and guide it forwards (17).
vertical
swivelling range
vertical
aperture angle
horizontal
swivelling range
horizontal
aperture angle
Figure 17: Dismantling the call push-button module
(19) Call push-button module cover
Defective covers can only be replaced by co-
P
vers with the same number of push-buttons.
Remove the module to be replaced and install
the new module in reverse order.
Open door station
Position the opening tool (16) at the bottom in
P
(7)
(19)
cover
the middle and press up (Figure 18).
With two-series door stations, use the opening
tool in the middle under each series of call
push-buttons.
The door station will spring out of the bottom
interlocking mechanism forwards and can be
opened.
Figure 18: Opening of the door station
(16)