Debug Lacp - Cisco WLC 5700 Series Command Reference Manual

debug lacp

debug lacp

To enable debugging of Link Aggregation Control Protocol (LACP) activity, use the debug lacp command
in privileged EXEC mode. To disable LACP debugging, use the no form of this command.
debug lacp [all | event | fsm | misc | packet]
no debug lacp [all | event | fsm | misc | packet]
Syntax Description
all
event
fsm
misc
packet
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
Cisco IOS XE 3.2SE
Usage Guidelines
The undebug etherchannel command is the same as the no debug etherchannel command.
When you enable debugging on a stack, it is enabled only on the active controller. To enable debugging on
the standby controller, start a session from the active controller by using the session switch-number command
in privileged EXEC mode. Enter the debug command at the command-line prompt of the standby controller.
To enable debugging on the standby controller without first starting a session on the active controller, use the
remote command switch-number LINE command in privileged EXEC mode.
Examples This example shows how to display all LACP debug messages:
Controller# debug LACP all
This example shows how to display debug messages related to LACP events:
Controller# debug LACP event
Layer 2/3 Command Reference, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
22
(Optional) Displays all LACP debug messages.
(Optional) Displays LACP event debug messages.
(Optional) Displays messages about changes within the LACP finite state machine.
(Optional) Displays miscellaneous LACP debug messages.
(Optional) Displays the receiving and transmitting LACP control packets.
Layer 2/3 Commands
Modification
This command was introduced.
OL-32323-01