Assembling the neat seam beginning (NSB)
2.4 Assembling the NSB into the machine
Order
1. Complete the presettings outside of the machine ( p. 5).
2. Check/adjust the cutting pressure ( p. 7).
3. Check/adjust the clamping spring pressure ( p. 8).
4. Assemble the NSB.
5. Activate the NSB ( p. 15).
To assemble the NSB into the machine:
Important
1. Remove the throat plate slide.
2. Disassemble the throat plate ( Service Instructions).
3. Disassemble the feed dog ( Service Instructions).
4. Disassemble the short thread trimmer knife ( Service Instructions).
5. Tilt the machine head.
Fig. 6: Assembling the NSB into the machine (1)
(1) - Screws
6. Insert the NSB from the bottom.
7. Tighten the NSB (1) using the screws.
8. Erect the machine head.
Additional Instructions M-TYPE DELTA - 00.0 - 05/2020
• Adjust the stitch length to 0.1
• Do NOT switch off the machine
• Lock the sewing feet in place
• Press the Service Stop key
①
9