Installation - Tripp Lite B127-1A1-CH Owner's Manual

Installation

Notes:
1) Test to ensure the entire installation works properly before pulling
cables through ceilings/walls.
2) To achieve maximum distance and performance, use 24 AWG solid-
wire Cat6 cable. Using stranded-wire Cat6 cable, or cable with a gauge
(AWG) size higher than 24 AWG, will result in a shorter extension distance.
Higher gauge cabling, such as 26 AWG, has a more limited transmission
capability than lower gauge cabling. All Tripp Lite N202-Series Cat6 cables
are made with 24 AWG solid-wire cabling.
3) External power is not required for remote receiver units due to Power
over Cable (PoC) technology incorporated in the transmitter units.
B127-1A1-CH
Extender Kit
LOCAL
TRANSMITTER
1. Ensure all equipment in the installation – such as TVs/
monitors, laptops and the transmitter – is powered OFF.
2. Using a USB Type-C cable (such as Tripp Lite U420-Series
cables), connect the USB-C source to the INPUT port on the
local transmitter unit.
02-173-933C55.indb 6 02-173-933C55.indb 6
1 Up to 125 ft. (38 m) Cat6 cable at 4K/60 Hz
2 Up to 15 ft. (4.5 m) HDMI 2.0 cable at 4K/60 Hz
3 Up to 9 ft. (2.7 m) Type-C cable at 4K/60 Hz
MONITOR NOTEBOOK
Up to 125 ft. (38 m) at 4K/60 Hz
6
REMOTE
RECEIVER
3/18/2020 9:28:36 A 3/18/2020 9:28:36 A