Philips SmartPro Active Manual page 17

Fan speed buttons
You can use the fan speed buttons to increase the fan speed to turbo or to
switch off the fan. The default setting is normal fan speed.
1 Turbo fan speed increases the suction power of the robot.
1
2 You can switch off the fan by pressing this button.
3 Press this button for normal fan speed.
2
3
Clap response
- When all icons on the display flash, the robot is malfunctioning.
To stop the icons flashing and see what is wrong, clap you hands once.
This makes the error code appear on the display. See chapter 'Error
codes' for the explanation of what these error codes mean.
Using the dry wipe attachment
The dry wipe attachment is a feature that allows you to clean hard floors
with dry wipes.
Preparing the dry wipe attachment for use
1 Turn the robot upside down and place it on the floor or on a table.
2 Place the dry wipe on a table and place the dry wipe attachment on
the wipe with its fixation lugs pointing towards you.
3 Fold both ends of the dry wipe around the dry wipe attachment
and fasten the dry wipe onto the attachment by pushing the fixation
blocks into the recesses.
4 Insert the fixation lug of the dry wipe attachment into the opening
just behind the wheel on one side of the robot and push until you
hear it lock into place with a click. Then repeat these actions on
the other side.
5 Turn the robot and place it on the floor on its wheels with the dry
wipe attachment touching the floor.
Using the robot with the dry wipe attachment
When the dry wipe attachment is attached, you can use the robot in any
mode and on all hard floors. Do not use the dry wipe attachment on
carpet or rugs.
ENGLISH
17