Advertisement
VER
Firmware Version
An explanation of all available functions can be found below:
ADDR: With this function, you can determine the DMX start address of the device. Set it channel 001, and
the device will respond to DMX channel 1. Set it to channel 003, then the device will respond to DMX
channel 3 and so on.
CHND: This device can operate with various DMX channel modes. If your DMX circuit is reasonably full with
devices and you do not need extensive control over the functions, a concise channel mode can be selected.
It is also possible to select a more extensive channel mode, making more channels available for the control
of several separate functions.
SLND: Using the Master / Slave Mode, it's possible to connect several devices of the same type with one
another, via DMX 3-pin XLR cables so that they perform exactly the same movements and functions at the
same time. Therefore, single devices do not respond individually (or chaotically) and this results in a
completely coordinated show. In the Master / Slave function, the first device in the circuit is set as the Master
and does not receive DMX signal.
PLEASE NOTE: When Slave mode is activated, the device shall wait for a signal from the designated Master
device. Selecting an automatic or sound-controlled mode is then not possible! To cancel the Slave mode,
enter the 'SLND' menu and select 'NAST'. This then sets the device to Master mode and the stand-alone
functions can then be activated once more.
COLO: Select one of the 15 built-in static colour presets. Then add an optional stroboscope effect.
JUMP: Alternate between diverse colours. One colour preset jumps to the next colour preset in one go. Then
add an optional stroboscope effect.
FADE: Slow colour fade with adjustable speed. One colour blends smoothly into the other. Then add an
optional stroboscope effect.
MANU: This is the manual colour mix function. Select a master level, add an optional stroboscope effect and
set a value per basic colour (red, green, blue, white) to mix a colour according to your preference.
SOUN: Deze instelling geeft aan of de microfoonfunctie van het apparaat in- of uitgeschakeld moet zijn. Dit
wordt aangegeven met de ON of OFF melding.
SENS: This mode allows you to set the sensitivity of the in-built microphone. The further the device is
installed from the sound-source, the higher the sensitivity of the microphone needs to be so that the sound is
registered and the device responds accordingly and in time to the music. The microphone is able to
withstand high sound pressure. However, if the sound is loud and the sensitivity is high, the microphone will
find it more difficult to register the beat. Experiment with the sensitivity and distance from the positioning of
the device to make sure you're getting the best possible signal and optimum performance.
DIMC: Add the Dim Curve from the LED-engine, so that a halogen lamp can be simulated (for example). All
the different dimming curves can be experimented with to produce varied effects by dimming the LED in
relation to the rising or falling DMX value.
BLND: Use this function to set what the device will do in the event of DMX signal drop-out or loss. When set
to Master mode, the device shall start an in-built programme. In the LAST mode, the device remains in the
last active DMX command received. In the Blackout mode, all settings return to zero and that device no
longer moves or gives light.
LED: When the LED display is not in use, it can be switched off. By setting 'LED' to 'Off', this will prevent red
symbols from illuminating when the device is being used in dark spaces. If you press of the menu buttons,
the display shall immediately light up and show all necessary information. If the display is not used, it shall
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials: 07-10-2019 RV
Displays current version of firmware installed.
This cannot be adjusted or changed
Revision date and author's initials: -
Advertisement
