Advertisement
The device is not reacting properly
to DMX commands
The operation mode can not be
changed
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials: 07-10-2019 RV
Signal loss or interference in the
DMX circuit
Incorrect DMX channel mode
The device is in Slave mode
Close the DMX circuit with a
terminator or connect a booster
after maximum 32 fixtures.
Check that the correct DMX
channel mode is set
If the device is in Slave mode, it
will wait for a master signal unless
there is a DMX signal present. Set
the device to Master to activate the
sound-controlled or automated
operation modes.
Revision date and author's initials: -
Advertisement
