Advertisement
To activate the device, plug it into a mains socket. Once it's connected to an active power source, it will turn
on automatically.
The device cannot be operated while it is still starting up and displays the 'AYRA' logo. Once the device has
fully started up, it will automatically jump to the last mode and setting. Operation modes and other settings
shown on the display can now be adjusted or changed via the menu buttons.
If a DMX signal is detected, the device shall automatically switch to DMX mode and the DMX address that
was last used. For a new device, this is usually DMX address 001. The DMX address can of course be
changed via the display and menu buttons.
The functions, modes and settings can be changed by using the display and menu buttons. Push 'Enter' to
select a function or to confirm a change. Push 'Up' and 'Down' to change any values and push the 'Menu'
button to return to the main menu. A few seconds after confirming a setting by pressing 'Enter', the device
shall automatically return to the main menu and perform the set actions. This can be sped up by holding the
'Menu' button down for 2 seconds after confirming a setting by pressing 'Enter'. This is usually done after
adjusting the working mode or DMX address.
The Menu includes the following options and fuctions:
Display
Mode
ADDR / A001
DMX Address Configuration
CHND
Channel Mode Selection
MASL
Slave Mode
COLO
Fixed Colours kleuren
JUMP
Colour Jump Mode
FADE
Colour Fade Mode
MANU
Manual Mode
SOUN
Sound-Controlled Mode
SENS
Sound Sensitivity
DIMC
Dim Curve
BLND
Blackout Mode
LED
LED Display On / OFF when not
in use
DISP
Display Inversion
TEST
Test Mode
TEMP
Temperature Display
FHRS
Duration of use
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials: 07-10-2019 RV
Operation and Mounting
Function
Address A001 ... A512
5CH / 7CH / 9CH
Master
Slave
CO 1-15 Colour presets
STRO 0-100 (Stroboscope effect, slow to fast)
JU 1-100 (Colour jump effect, slow to fast)
STRO 0-100 (Stroboscope effect, slow to fast)
FA 1-100 (Colour fade effect, slow to fast)
STRO 0-100 (Stroboscope effect, slow to fast)
STRO 0-100 (Stroboscope effect, slow to fast)
DIMM 0-100 (Master Dimmer 0-100%)
RED 0-100 (Dimmer Red 0-100%)
GREE 0-100 (Dimmer Green 0-100%)
BLUE 0-100 (Dimmer Blue 0-100%)
WHIT 0-100 (Dimmer White 0-100%)
Mode: ON / OFF
0 - 100: Sensitivity in %
HALO Halogen simulation
LI Linear
EO Exponential
LO Logarithmic
SC S-curve
NO: Fixture switches to auto stand-alone
operation in event of DMX signal loss
YES: Fixture switches to blackout in event of
DMX signal loss
ON/OFF
Display Invert, disp - dslp
Test programme to check the operation of each
LED by illuminating each LED one by one
Displayed in Degrees Celsius
0000 – 9999 Hour of use
Revision date and author's initials: -
Advertisement
