Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for x-sense XS01-WR
Summary of Contents for x-sense XS01-WR
- Page 1 User Manual XS01-WR Wireless Interlinked Smoke Alarm...
-
Page 2: Package Contents
IF THE ALARM CANNOT WORK PROPERLY, IT WILL NOT ALERT YOU TO A PROBLEM. Set up and Interconnect Smoke Alarms All XS01-WR alarms contain a built-in RF module that enables you to wirelessly connect 2 or more smoke alarms and 1 × Alarm Unit 1 ×... -
Page 3: Alarm Test
2. Test all your wireless smoke alarms to ensure that they are interconnected before installation. 3. A maximum of 24 wireless smoke alarms can be interconnected. 4. Note that the X S01-WR alarm can only be interconnected with other X-SENSE wireless alarms. How to Disconnect... -
Page 4: Installation Positioning
Installation Positioning Test a single alarm Test all interconnected smoke alarms Action Press the test/silence Hold down the test/silence button. button. Indication • The alarm will sound 3 • The initiating smoke alarm will beep continuously with the red short quick beeps. LED fl... - Page 5 1. Prioritize the installation of an alarm in the bedroom and walkways, and make sure you can hear the alarm from all sleeping areas. In a home with several bedrooms, install an alarm in every bedroom. If you install only one smoke alarm in your home, install the alarm near to all bedrooms where possible, and not in a basement or furnace room.
-
Page 6: Installation Method
Loc ations to Avoid 1. Nea r large metal surfaces and/or bundles of wire. 2. Near fl uorescent lights, amateur radios, electrical equipment, or other devices that may transmit an RF signal, a s electronic “noise” may cause nuisance alarms. WARNING! 1. -
Page 7: Silence Mode
LED Indicator and Audible Alarm Low Battery Red LED flashes 1 beep every 60 Each alarm gives once every 60 seconds an independent seconds. warning. Status LED indicator Audible alarm Action Normal Red LED fl ashes None once every 60 seconds. -
Page 8: Technical Speci Cations
About 9 minutes Operating Frequency 915 MHz Maximum Number of Interconnected Units 24 wireless units (only compatible with X-SENSE wireless alarms) Transmission Range Over 820 ft (250 m) in open air Note: Battery life is calculated based on the current rating in the weekly testing mode and the standby mode. If its operation... -
Page 9: Troubleshooting
• Make sure you push the central test button fi rmly. X-SENSE Technology Co., LTD. • Check the installation positioning. The wireless signal might be Address: Tower B, Qiaode Technology Park, No. 7 Road, Guangming District, Shenzhen, Guangdong Province, China blocked or out of range. - Page 10 X-SENSE Technology Co., LTD. Email: support@x-sense.com...
Need help?
Do you have a question about the XS01-WR and is the answer not in the manual?
Questions and answers