Pre-Installation Info - Stern Engineering EXTREME BRE Series Installation And Maintenance Manual

PRE-INSTALLATION INFO

Check contents
Separate all parts from the packaging and check each part with
the "Pack contents" section.
Pay attention to the different models variations.
Make sure all parts are accounted for before discarding any
packaging material.
If any parts are missing, do not attempt to install your electronic
faucet until you obtain the missing parts.
Warnings
Do not install the system facing a mirror or any other electronic
system operated by an infra-red sensor.
To prevent reflection problems, it is recommended to keep a
minimum distance of 1.50 meters between the faucet and any
other objects.
Do not place the transformer or transformer box close to other
cables related to the building infrastructure.
Preparation for installation
Flush water supply lines thoroughly before installing the faucet. Do
not allow dirt, Teflon tape or metal particles to enter the faucet.
Shut off water supply.
Important
All plumbing is to be installed in accordance with applicable
codes and regulations.
4