Supply Voltage; Emergency Stop; Connecting Of Supply Voltage - Parker IQAN-L Series Instruction Book

Supply Voltage

C
AUTION
Before any installation of the IQAN system can take place, make sure the ignition lock
is turned off and the battery is disconnected.

Emergency stop

Make sure an Emergency Stop disconnecting the power supply, is easily accessible at
any time. The figure below shows how to connect the emergency stop.

Connecting of Supply Voltage

The supply voltage, should be within the operating range, see Appendix A, on page
xxiii.
Connect the supply voltage to +BAT pin C1:4 through a fuse. The fuse shall be 3A fast
(F). The ground connection is made from -BAT pin C1:1 to the negative pole on the
battery.
+BAT, pos. C1:4
3A fast
-BAT, pos. C1:1
*This is a symbol for disconnecting
switch for battery, ignition lock and
other fuses.
Connecting the emergency stop and voltage supply.
N
OTICE
Do not use the chassis as the negative terminal.
Instruction book, IQAN- Lx
E-stop
*
+
Supply Voltage
6 Installation
-
xv