Mounting; Mounting The Unit; Mounting Considerations - Parker IQAN-L Series Instruction Book

5

Mounting

Mounting the unit

N
OTICE
The IQAN-Lx unit should be mounted according to the following instructions.

Mounting considerations

• The control lever must be built in so that it is protected against damp, dirt and
mechanical damage.
• The machine manufacturer must consider the need of a protective catch, or similar,
to prevent unintentional working of the lever
N
OTICE
Take careful consideration when positioning the unit.
• Mount the unit so that it is not exposed to external heat, e.g. from the engine or
heater
• Mount the unit so that the LEDs are visible
• Mount the unit so there is no risk that the harness can be folded, crushed, worn or
damaged in any way
• Locate the harness so there is no pressure on the connector.
• Use ergonomics. The control lever should be mounted at a height so that there is no
pressure on the driver's arm and shoulders. IQAN-LM should be mounted at an
angle so that the driver's wrist is held normally. The IQAN-LL combined with
moveable arm rests can provide good ergonomics.
15
Always consider ergonomics when installing hand controls.
• The control lever IQAN-LM with 3rd axis is intended to be positioned so that the
rocker is manoeuvred with the thumb.
Instruction book, IQAN- Lx
Mounting the unit
5 Mounting
xi