Philips WP4161/90 User Manual page 24

Water outlet
Lever
Rubber
washer
Metal
Lock nut
washer
Adapter
(2) Installation of faucet
Select an appropriate installation location on the sink
or table; please make sure the surface smooth within a
5cm radius of the installation location is horizonal; drill
a small hole with a diameter of 16mm;
Install the faucet properly according to the installation
drawings.
(3) Installation of batteries
Notes:
for WP4161/01 and WP4161/91 only
Open the battery box lid of the lter head; unscrew the
moisture-proof cover; put three batteries into the
battery case; then properly install the moisture-proof
cover and the battery box lid.
(4) Installation of the lter cartridge
Screw the lter cartridge into the lter cover according
to their respective positions and the direction as shown
in the gure.
(5) Installation of water ltration system
Please choose whether to install the screw by using the
plastic anchors according to the actual conditions of the
mounting surface;
The mounting distance between two screws should be up
to 232mm, and the screw thread should be exposed to 12
~15mm;
Hang the installed machine on the screw;
Cut the 3/8 PE pipe into two sections; take one of the
sections, insert one end into the water inlet, and install
the other end on the three-way ball valve; take another
section, insert one end into the water outlet of water
puri er, and insert the other end into the adapter of
faucet;
Turn on the cold water valve.
19