Mercury VesselView 4 Manual page 48

Section 4 - Setup and Calibrations
Depth Offset >
Sea Temperature >
Speed >
Steering >
Location: port, port center,
Tanks >
starboard center, starboard >
Location: port, port center,
Trim >
starboard center, starboard >
Tab source >
Tabs >
Starboard and port calibration
Page 44
SmartCraft
Calibration: offset,
zero, restore
None, PCM0,
PCM1, PCM2,
Sea temperature
PCM3, AirMar0,
source >
AirMar1, AirMar2,
AirMar3
Calibration: offset,
Offset >
zero, restore, save
GPS source > CAN‑P or H
None, PCM0,
Pitot speed source
PCM1, PCM2,
>
PCM3,
Pitot sensor type > 100 or 200 PSI
Calibration:
Pitot multiplier > multiplier and
restore, save
None, PCM0,
Paddle speed
PCM1, PCM2,
source >
PCM3
Paddle speed
Legacy or Airmar
sensor >
Calibration:
Paddle frequency > multiplier and
restore, save
None, PCM0,
Steering angle
PCM1, PCM2,
source >
PCM3, TVM
Turn on (check
mark) to invert
steering, or off (no
Invert steering
checkmark), which
engine to show
steering
Calibration: offset,
Offset >
zero, restore, save
Tank 1 or 2 > Calibration >
None, fuel, oil,
Tank usage >
water, waste
Capacity > 0 up to six digits
Turn on (check
Has trim mark) or off (no
checkmark)
Set trim in,
maximum trim
Calibration >
range, full trim out,
reset, restore, save
None, PCM0,
PCM1, PCM2,
PCM3, TVM
Number of Set tab down, mid,
calibration points (2 up range, reset,
or 3), restore, save
— —
—
—
—
—
—
—
—
—
—
—
—
—
Empty, 1/4, ½, 3/4, full
—
—
—
—
— —
—
90-8M0087257 DECEMBER 2014
eng