Power Package Recommissioning - Mercury 1.7 MI Manual

SECTION 6
CE502

Power Package Recommissioning

Refer to Cold Weather Or Extended Storage precautions, BEFORE proceeding.
1. Install the seawater pump impeller after ensuring that the splines are not worn and
inspecting it for worn or damaged vanes.
a. Remove the seawater pump cover mounting screws.
b. Remove the seawater pump cover and O-ring.
c. Install the seawater pump impeller into the housing by turning clockwise while simul-
d. Install a new O-ring on the seawater pump.
e. Install the seawater pump cover.
f.
b
2. Ensure that all cooling system hoses are in good condition, connected properly, and
hose clamps are tight.
3. Verify that all drain valves and drain plugs are installed and tight.
4. Inspect all drive belts.
CMD-3967823 / 90-865237030 OCTOBER 2003
INDEX
taneously pushing inward.
Install the seawater pump cover mounting screws. Tighten the screws evenly in a
diagonal pattern. Tighten the screws securely.
c
d
a - Mounting screw (4)
Cover
b -
c - Impeller
d - O-ring
NOTICE
b
a
79742
STORAGE
79743
Page 97