Operation; After Use - Sandstrom S300SB14E Instruction Manual

Operation

1. Make sure the bottle and the blade assembly are secure and in the lock
GB
position.
2. Plug your blender into the mains socket and switch on the power.
3. Press and hold the
blender will continue to blend as long as the
4. To stop the operation, release the
• Do not run the blender continuously for more than 1 minute. After a full
30 seconds cycle, allow the blender to rest for another 90 seconds before
using it again.
• Never blend very hot liquids in the blender. This is dangerous as the contents
may erupt.
• If you spill liquid on the base immediately switch off and wipe dry.
• If the motor stalls turn off the blender immediately, unplug the blender and
let it cool for at least 10 minutes.

After Use

After you have finished blending:
1. Unplug the blender from the mains socket.
2. Turn the bottle and blade assembly anti-clockwise to unlock and
remove it from the base of the blender.
3. Unscrew the blade assembly, spoon out the contents carefully or
replace with the spill-proof lid.
24
button, the blender will start blending. The
button.
button is pressed.