Table of Contents
Advertisement
1. Cutting unit kickstand
3
Adjusting the Rear Shield
No Parts Required
Procedure
Under most conditions, the best dispersion is attained when
the rear shield is closed (front discharge). When conditions
are heavy or wet, the rear shield may be opened.
To open the rear shield
(Figure
the shield to the left side plate, rotate the shield to the open
position, and tighten the bolt.
1. Bolt
Figure 3
4), loosen the bolt securing
Figure 4
2. Rear shield
4
Installing the Loose Parts
Parts needed for this procedure:
1
Straight grease fitting
1
O-ring
Procedure
The grease fitting must be installed on the reel-motor side of
the cutting unit. Refer to
of the reel motors.
g191340
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1. Remove and discard the setscrew on the reel-motor
side plate
(Figure
G028640
1. Cap screw (2)
2. Setscrew
g191341
2. Install the straight grease fitting
3. If there are no cap screws on the reel-motor side plate,
install them
5
Figure 5
to determine the position
Figure 5
5. Cutting unit 5
6. Reel motor
7. Weight
6).
Figure 6
3. Grease fitting
4. Grease vent
(Figure
(Figure
6).
g031275
g028640
6).
Advertisement
Table of Contents
