1. Kickstand
5
Adjusting the Rear Shield
No Parts Required
Procedure
Under most conditions, best dispersion is attained when the
rear shield is closed (front discharge). When conditions are
heavy or wet, the rear shield may be opened.
To open the rear shield
(Figure
securing the shield to the left side plate, rotate the shield to
the open position, and tighten the cap screw.
Figure 9
10), loosen the cap screw
1. Rear shield
6
Mounting the Counterweights
No Parts Required
Procedure
All cutting units are shipped with the counterweight mounted
to the left end of the cutting unit. Use the following diagram
to determine the position of the counterweights and reel
motors.
Note: Some traction units have only 5 cutting units.
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
5. Cutting unit 5
1. On cutting unit numbers 2, 4, and 6, remove the 2
cap screws securing the counterweight to the left end
of the cutting unit.
7
Figure 10
2. Cap screw
Figure 11
6. Cutting unit 6
7. Cutting unit 7
8. Reel motor
9. Weight