Servicing The Bedbar - Toro Edge Series Operator's Manual

1. Angle-indicator mount
2. Edge of the magnet mated
with the edge of the
bedknife
4. Place the angle indicator on the mount as shown in
Figure 29.
Note: This is the angle that your grinder produces; it
should be within 2 degrees of the recommended top
grind angle.

Servicing the Bedbar

Removing the Bedbar
1. Turn the bedbar-adjuster screws counterclockwise to
back the bedknife away from the reel
1. Bedbar-adjusting screw
2. Spring-tension nut
2. Back out the spring-tension nut until the washer is no
longer tensioned against the bedbar
3. On each side of the machine, loosen the locknut
securing the bedbar bolt
Figure 29
3. Bedknife
4. Angle indicator
(Figure
Figure 30
3. Bedbar
4. Washer
(Figure
(Figure 31).
1. Bedbar bolt
4. Remove each bedbar bolt, allowing the bedbar to be
g034114
pulled downward and removed from machine bolt
(Figure
Note: Account for 2 nylon washers and 1 stamped
steel washer on each end of the bedbar
30).
1. Bedbar bolt
2. Nut
Assembling the Bedbar
1. Install the bedbar, positioning the mounting ears
between the washer and the bedbar adjuster.
2. Secure the bedbar to each side plate with the bedbar
bolts (nuts on bolts) and 6 washers.
Note: Position a nylon washer on each side of the
side-plate boss. Place a steel washer outside each of the
nylon washers
g016647
3. Torque the bedbar bolts to 37 to 45 N∙m (27 to 33
ft-lb).
Note: Tighten the locknuts until the outside steel
washer stops rotating and end play is removed, but do
not overtighten or deflect the side plates. The washers
on the inside may have a gap.
30).
4. Tighten the spring-tension nut until the spring is
collapsed, then back off 1/2 turn
17
Figure 31
2. Lock nut
31).
Figure 32
3. Steel washer
4. Nylon washer
(Figure 32).
g003334
(Figure 32).
g003335
(Figure 33).