Replacing A Power Supply - Brocade Communications Systems Backbone DCX 8510-8 Hardware Reference Manual

FIGURE 28 Removal and replacement of the power supply

Replacing a power supply

To replace a power supply, complete the following steps.
1. If you are not replacing the power supply, insert a filler panel into the slot.
2. Otherwise, insert the power supply into the slot. Verify that the power supply is seated by gently
pulling on the handle.
3. Tighten the thumbscrew.
4. Replace the power cord.
5. Latch the power cord retainer clip.
6. Turn on the power switch.
Brocade DCX 8510-8 Backbone Hardware Reference Manual
53-1002180-08
Replacing a power supply
97