Installation of the Brocade DCX 8510-8
●
Time and items required................................................................................................. 23
●
●
●
●
●
Port numbering................................................................................................................27
●
Chassis slots................................................................................................................... 29
●
Cable management.........................................................................................................29
Time and items required
You can set up and install the Brocade DCX 8510-8 in the following ways:
• As a standalone unit on a flat surface.
• In a 19-inch Electronic Industries Association (EIA) cabinet, using the 14U Rack Mount Kit (provided).
• In a mid-mount telecommunications (Telco) rack, using the Mid-Mount Rack Kit available from your
Brocade DCX 8510-8 supplier.
This chapter describes how to set up the Brocade DCX 8510-8 as a standalone unit. For rack-mount
installation instructions, refer to the appropriate manual as described in the following table.
The following table describes the main installation and setup tasks, the estimated time required for
each, and the items required to complete the task based on a fully populated Brocade DCX 8510-8 (512
Fibre Channel ports using the FC16-64 port blades). Configurations with fewer ports require less time.
These time estimates assume a prepared installation site and appropriate power and network
connectivity.
TABLE 2
Installation task
Site preparation and unpacking
Brocade DCX 8510-8
Installing rack mount kit
Mounting and securing Brocade
DCX 8510-8 in rack
Brocade DCX 8510-8 Backbone Hardware Reference Manual
53-1002180-08
Installation tasks, time, and items required
Time estimate
30 minutes
30 minutes
30 minutes
Items required
1/2-in. socket wrench (to remove pallet bolts).
#2 Phillips screwdriver(for cable management comb).
Pallet jack.
Hydraulic lift or assisted lift, able to raise to a minimum of
140 cm (55 in.), with a minimum capacity of 115 kg (254
lb). The Brocade DCX 8510-8 weighs 161.2 kg (355 lb)
with eight FC16-64 port blades installed (512 ports).
Refer to the 14U Rack Mount Kit Installation Procedure or
the Mid-Mount Rack Kit Installation Procedure.
23