Braun Oral-B GENIUS 8000 Manual page 9

Caution: Follow your smartphone's user
manual to ensure your phone/charger is
designed for use in a bathroom environ-
ment.
Check www.oralbappavailability.co.uk
for country availability of the Oral-B™ App.
Cleaning
recommendations
After brushing, rinse your brush head under
running water with the handle switched on.
Switch off and remove the brush head.
Clean handle and brush head separately;
wipe them dry before reassembling. Unplug
the basic charger/charging stand before
cleaning (picture 5).
To be cleaned with a damp cloth only:
charger (9), charging travel case (12), basic
travel case (15) and smart plug (13).
Dishwasher-safe: brush head compartment
and protective cover (10), removable inlay
(12e) of the charging travel case (picture
B3).
Hand wash: beauty bag (14) only with luke-
warm water (30°C – 40°C).
Accessories
(depending on model)
Smartphone Holder
• Before each use, make sure mirror, suc-
tion cup surface (11d) and holding brack-
ets (11a) are always clean and dry (picture
B1). Use a fuzz-free cloth for cleaning
suction cup surface and mirror. In particu-
lar make sure suction cup surface and
mirror are free from any contamination
(e.g. hair, dust, oil, fuzz, dirt etc.).
• Press your smartphone holder (11) just
with enough pressure, centered at nose
level on a sturdy mirror. Then mount the
holder by pressing the lever arm (11b)
towards the mirror until it snaps in (picture
B2).
Note: Only affix on mirror to ensure safe
and correct conditions. For use in bath-
room only. Do not use in automobiles.
• Always make sure the smartphone holder
is securely mounted on the mirror before
inserting your smartphone. Place your
smartphone (portrait) sideways in
between the holding brackets (11a) by
10
pressing against one bracket with your
phone and sliding the other bracket to the
side (picture B2). Follow the same proce-
dure to remove your phone again.
• Adjust the overall position for the required
angle by moving the ball joint of the
holder (picture B3).
• Once done, remove your phone from the
holder. Take off the smartphone holder by
flipping the lever arm back and pulling the
tab carefully (picture B4 1./2.). Affix
smartphone holder with each use again.
• The smartphone holder should be
cleaned with a damp fuzz-free cloth only
(picture 5). You may use glass cleaner,
alcohol or similar products (avoid prod-
ucts with silicone oil). Make sure the sur-
face is dry and dust free after cleaning.
Store in clean and dry place. If not in use,
always remove your smartphone from the
holder.
Note: Smartphone width required for usage:
minimum 58 mm, maximum 83 mm.
Caution: Small parts may come off, keep
out of reach of children.
Follow your smartphone's user manual to
ensure your phone/charger is designed for
use in a bathroom environment.
Charging Travel Case
• To charge your handle (5) place it on the
pin in the charging travel case (12) and
connect it to an electric outlet, using the
extra smart plug (13) provided. The smart
plug may be used for all global mains volt-
age ranges (100 -240V).
• The flashing light (12a) of the charging
travel case indicates that the handle is
charging. Once the handle is fully charged
the light turns off. A full charge can take
up to 12 hours (picture C1).
Note: You may use the USB port (12b) to
charge an electric device while the charg-
ing travel case is plugged in. The handle
can only be charged with the smart plug
(13) (12c) not via USB port.
• The inner lid of the travel case has a
built-in smartphone holder (12d), which
can hold your smartphone while using
(picture C2). Before use, make sure your
phone fits the stand and keeps stable.
• The removable inlay (picture C3) (12e)
of the travel case is dishwasher-safe