Polycom iPower 900 Series Installing Manual page 12

I N STA LL I N G A C O LL A B O RATI ON S Y STE M ON T H E P RE M IER CART
Installing the Back Brackets for the 32-inch (34-inch in Europe)
Monitor
12
Before you begin, note that you must follow these instructions
e xa c t ly to ensure that the monitor is installed safely.
If the brackets are not correctly installed, the straps won't
hold the monitor securely in place. The monitor could work
free of the front bracket, and tip.
To install the back brackets for the 32-inch (34-inch in Europe)
monitor:
1. Position the Velcro straps
loop side of the Velcro facing up.
You don't need to separate the loop side from the hook side.
2. Place the brackets on top of the straps, aligning the holes in the
brackets with the holes in the Velcro straps and the holes in the
grooves on the cart. Make sure that the loose ends of the straps
b
extend beyond the rear of the Premier Cart.
The two holes in the brackets must be aligned with the 3rd and
5th holes counting from the back of the cart (the brackets will
cover the 4th hole).
3. Insert the screws through the brackets and straps and into the
Premier Cart. Tighten the screws.
a
Warning
a on top of the cart, as shown, with the
b