Connect The Cold Wire Feeder To The Power Source; General; Variant 1: Gas Pipe Inside Interconnecting Hosepack - Fronius KD 7000 D-11 Operating Instructions Manual

Connect the cold wire feeder to the power source

General

The cold wire feeder is connected to the power source using the interconnecting hosepack.
Connect the cold
wire feeder to the
power source
Fitting the equipment incorrectly can cause serious injury and damage.
Do not carry out the steps described here until you have read and completely understood
all the operating instructions.
Variant 1: gas
pipe inside inter-
connecting hose-
pack
1
2
3
4
5
24
WARNING!
(1)
(2)
(1)
(11)(10) (9)
Plug the enclosed gas hose (1) into rear of current socket (2) and into shielding gas
connection socket (10)
Plug control plug (5) into torch control connection (3)
Plug welding potential bayonet plug (6) into current socket (2) and turn to fasten it
Plug LocalNet (4) plug into LocalNet port (11)
Tighten union nut on LocalNet plug (4)
Switch the power source mains switch
1
to the "Off" position
Remove the right side panel of the cold
2
wire feeder:
Undo the 5 screws
Remove the side panel
Cut open bushings for LocalNet con-
3
nection cable (1) and interconnecting
hosepack (2) on the rear of the power
source
Feed LocalNet connection cable
4
through bushing (1)
Feed interconnecting hosepack con-
5
nection cable through bushing (2)
(2)(3)
(2)
(10)
(8)
(9)
(8)
(3) (4) (5) (6)
(7)