Burn In (Write) Check - Sony HDPS-M10 Service Manual

7) Check that "Input Drive Data" screen is displayed.
8) Input serial No and media remarks.
For example:
Hard disk ............................................................ HDD(BIR)
9) Click "OK" button.
10) "Storage device test" is performed automatically.
11) Before the "Count" of the ERROR RATE window reaches
"76308", when the "Read error was occurred. Do you want to
continue?" message is displayed, the hard disk drive is
malfunction. Click the "No" button to abort the test.
12) When the "Count" of the ERROR RATE window reaches
"76308", the test is completed.
13) Check that the "Errors" window indicate "1".
Note: The "Errors" window (Errors count) will indicate "1" after the
"Count" reaches "76308", but this is not true error, so it is
considered that the hard disk drive has no error.
When the "Errors" window (Errors count) indicate "2" or more,
the hard disk drive is malfunction.
HDPS-M10
Fig. 3-1-19.
Fig. 3-1-20.
Fig. 3-1-21.
3-2-7.

Burn In (Write) Check

Mode
Power Supply
Test Program
MemoryStick
CompactFlash
Microdrive
Specified Value
Note: When the hard disk is checked, the data memorized on hard disk
will be erased. After the hard disk check finishes, perform "3. HDD
Self Format" again.
Checking method:
1) Turn on the power of HDPS-M10.
2) Connect HDPS-M10 and PC using the USB cable.
3) Double click "80minAg.exe" of the "Bi(w)" folder, and start
"Storage device test" on the PC.
4) Check that "Storage device test" screen is displayed.
5) Set up "Storage device test" as follows.
Drive name (Note)
Read
Write
Random
Verify
Time out setting
Automatic
If error occurred,
display warning
Note: The drive letter (e.g., "G:") differs depending on the PC.
6) Click "Test Start" button.
3-10
USB
AC power adaptor
80minAg.exe
Not necessary
Not necessary
Not necessary
Hard disk drive:
Error rate = 5.000000E – 002 or less
Fig. 3-1-22.
G
No check
Check
Check
Check
4000msec
No check
No check