v Reset Configuration to Default
v Restart HD-PDU
Setting the IP address
Note: You must set the IP address before you can use the Web interface.
To set the IP address of the PDU, in the Configuration Utility main menu, select
IBM DPI Settings and then select Set the IP Address, Gateway Address and
MIB System Group. You must set the IP address before you can access the PDU
in an IP network (LAN/WAN). Contact your system administrator if you do not know
the IP address.
24
DPI C13 PDU+, DPI C19 PDU+, and DPI C19 3-phase PDU+: Installation and Maintenance Guide
– Set IBM DPI Information
Select this choice to configure the PDU logging interval, refresh rate, and
custom name fields for the load groups.
– Settings and Event Log Summary
Select this choice to view all PDU configuration settings.
Select this choice to reset all system settings to their factory default values.
Select this choice to restart the PDU.