VGE XCLEAR FLOW-MATIC Manual page 7

Important safety instructions read and follow all instructions!
• Adjustable rinse time (0.5 to 5 minutes).
• Starts and stops recirculation pump and blower.
• Compatible with Blue Eco pumps for automatic pump speed changes.
• Made in the Netherlands.
ADVANTAGES
• Less pressure loss, more flow, energy saving.
• Easy to install and to maintain.
• Replaces the traditional multiport valve.
• Fits to all brands of beadfilters with side mount connection.
• 2-year warranty covering manufacturing defects.
SAFETY INSTRUCTIONS
1. Warning - due to the risk of injury, this product is not suitable for use by children or
persons (including children) with reduced physical, sensory or mental capabilities, or lack
of experience or knowledge, unless they are supervised or instructed on the use of the
device by a person responsible for their safety.
2. Warning - risk of electric shock. If in doubt as to whether you have sufficient knowledge
and experience, this device must always be connected by a certified electrician, according
to the locally applicable standards and laws, with a properly earthed connection protected
by a residual-current device.
3. Warning - to reduce the risk of electric shock, a damaged cable should be replaced
immediately.
4. Warning - to reduce the risk of electric shock, the use of an extension lead is not
recommended. Connect the device to an easily accessible mains outlet.
5. Do not bury the connection lead. Never share connections and/or connection leads with
lawn mowers, hedge trimmers or other equipment.
6. Always install the device horizontally (see figure page 4 + 5).
7. Never install the unit at a location where it will be exposed to direct sunlight.
8. Keep children away from this device and the electrical lead.
9. During and after commissioning, the unit is operating and filled with water. Therefore,
to reduce the risk of electric shock, be careful during repairs and/or service work. If you
lack the necessary knowledge and experience, repair and/or service activities should be
performed by authorized/accredited technicians.
10. Never touch the appliance if it falls into the water! Disconnect the connection lead first,
before removing the unit from the water. Because electrical components are damaged
by water and therefore become unsafe, the device must be submitted to authorized/
accredited technicians for repair/maintenance.
11. The device must not be switched on if it has been damaged during or as a result of
transport, a fall, a production defect or other cause.
12. Always connect the device to an undamaged, earthed mains outlet with hinged cover.
XCLEAR FLOW-MATIC MANUAL |
EN
7