Advertisement
10. Place the Right Storage (D) onto the right side of the Base (A), as seen in the illustration below.
11. Align the pre-drilled holes on the top of the Base (A), to the pre-drilled holes on the Right Storage (D).
12. Insert from the bottom: 2 sets of Bolt (H), Spring Washer (I), and Flat Washer (J) through the pre-drilled holes on
the top of Base (A), to the pre-fixed insert nuts on the bottom of the Right Storage (D).
13. Tighten with Allen Key (K).
2 Sets
14. Open the door of the Right Storage (D).
15. Insert 6 sets of: Bolt (H), Spring Washer (I), and Flat Washer (J) through the pre-drilled holes on the left side
panel of the Right Storage (D), to the pre-fixed insert nuts on the right side panel of the Left Storage (C).
16. Tighten with Allen Key (K).
6 Sets
Date: 2013-May-7
Rev:
www.pbteen.com
Page 4 of 6
Advertisement
