Mounting; Orientation; Rigging - Venue Tetra 6 Manual

Mounting

The Tetra 6 includes a dual-yoke mounting system and safety loop for stable aiming from lighting stands,
trusses and floors. Before mounting the product, read and follow the safety recommendations indicated in
the Safety Notes

Orientation

The Tetra 6 may be mounted in any position; however, make sure adequate ventilation is provided around
the product.

Rigging

Be sure that the structure can support the weight of the fixture. Please see the "Technical Specifications"
section of this manual for a detailed weight listing. Mount the fixture securely. This may be done with a
screw, nut and bolt, or a hanging clamp (not included). The hole in each bracket can fit a ½ in. screw or
bolt. When rigging, consider routine maintenance and back panel access. Please see the following steps
for installation.
• Before deciding on a location for the product, always make sure there is easy access to the product for
maintenance and programming purposes.
• Make sure that the structure onto which you are mounting the product can support the product's weight.
See the Technical Specifications for weight information.
• When mounting the product overhead, always use a safety cable. Mount the product securely to a
rigging point, whether an elevated platform or a truss.
• When rigging the product onto a truss, use a mounting clamp of appropriate weight capacity.
• When power linking multiple products, mount the products close enough for power linking cables
to reach.
• The bracket adjustment knobs allow for directional adjustment when aiming the product to the desired
angle. Only loosen or tighten the bracket knobs manually. Using tools could damage the knobs.
www.venuelightingeffects.com
Mounting Clamp
Safety Cable
Bracket Adjustment
Knob (x2)
7