Setup; Ac Power; Placement/Mounting; Rigging - Venue tetra control Manual

SETUP

AC Power

This unit runs on 9 VDC, 1000mA (pin center positive). Before powering on the unit, check the output
of the power supply to be sure that it is correct. To determine the product's power requirements (circuit
breaker, power outlet, and wiring), use the current value listed on the product's back panel, or refer to the
product's specifications chart. The listed current rating indicates the product's average current draw under
normal conditions.
Always connect the fixture to a protected circuit (circuit breaker or fuse). Make sure the
product has an appropriate electrical ground to avoid the risk of electrocution or fire.
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the unit from power via breaker or by unplugging it.
Never connect the unit to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.

Placement/Mounting

The Tetra Control can be placed on any safe surface, or mounted to a microphone stand for easy access
during any performance.

Rigging

Be sure that the mic stand or mounting structure is sturdy and can support the weight of the Tetra Control.
Please see the "Technical Specifications" section of this manual for a detailed weight listing. Mount the
fixture securely by tightening the mounting clamp over the mic stand as shown in the illustration below.
Please see the following notes for best installation practices.
• Ensure that the clamp is fully tightened over the mic stand to avoid slipping during use.
• Ensure that cables are neatly organized and that no cables are tugging on the unit's
input/output jacks.
• There are rubber feet attached to the base, which may be used primarily for floor or desk
standing positions.
• The brightness of the backlight controls on the Tetra Control can be adjusted through
the settings menu to suit your performance space. See "Settings Menu" on page 11
for further instructions.
www.venuelightingeffects.com
7