Sound-Active (Audio); Audio Sensitivity (Threshold); Strobe (Flash); Level (Brightness) - Venue Tetra 6 Manual

STANDALONE OPERATION

SOUND-ACTIVE (AUDIO)

This fixture has 20 pre-programmed chases (10 switching and 10 fading) that use the built-in microphone
for sound-active response. These are accessed via the Control Display (page 8).
1. Press <MENU> until "A-" are the first two characters on the display screen.
2. Using <UP> and <DOWN>, select the desired program (C0-C9 for switching chases,
or F0-F9 for fading chases).
3. Press <ENTER> to confirm settings.

AUDIO SENSITIVITY (THRESHOLD)

At any time, you can adjust the sensitivity of the microphone for use alongside sound-active programs, via
the Control Display (page 8).
1. Press <MENU> until "t-" are the first two characters on the display screen .
2. Press <UP> or <DOWN> to adjust the sensitivity between 1 and 10
(1 = most sensitive, 10 = least sensitive)
3. Press <ENTER> to save your sensitivity setting.

STROBE (FLASH)

This fixture includes a strobe mode, with 14 color options. Refer to the "Control Panel Menu Selections"
chart on page 9 for a list of colors. The speed of the strobe can be adjusted via the Speed parameter
described above. This mode is accessed via the Control Display (page 8).
4. Press <MENU> until "F-" are the first two characters on the display screen .
5. Press <UP> or <DOWN> to select the desired strobe color (1-14).
6. Press <ENTER> to confirm settings.

LEVEL (BRIGHTNESS)

The brightness of standalone functions can be adjusted via the Level parameter. This setting is accessed via
the Control Display (page 8).
7. Press <MENU> until "L-" are the first two characters on the display screen .
8. Press <UP> or <DOWN> to select the desired brightness setting (1 = least bright, 99 = most bright).
9. Press <ENTER> to confirm settings.
CUSTOM STATIC COLORS / MANUAL CONTROL
This fixture has the ability to accept custom static color settings via the Control Display (page 8).
1. Press <MENU> until "MANU" appears on the display screen.
2. Press <ENTER>.
3. Using <UP> and <DOWN>, select the desired level for the red LEDs (r0-255)
4. Repeat steps 2-3 for green, blue, and amber (G0-255, b0-255, o0-255) until the desired color is obtained.
5. Press <ENTER> after all color selections to exit back to the main menu.
12
Venue Tetra 6 Manual