Setup; Ac Power; Power Linking - Venue Tetra 6 Manual

SETUP

AC Power

This fixture runs on 110~120 V-60 Hz. Before powering on the unit, make sure the line voltage is within the
range of accepted voltages.
To determine the power requirements for a particular fixture, see the label affixed to the bottom of the fix-
ture or refer to the fixture's specifications chart. A fixture's listed current rating indicates its average current
draw under normal conditions.
Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only
as a 0 to 100% switch.
Always connect the fixture to a circuit with a suitable electrical ground.

POWER LINKING

This fixture contains power linking via the outlet located on the back panel. Please see the diagram below
for further explanation.
The maximum quantity of fixtures that may be linked is 62 units @ 120V, 10A circuit max.
An IEC connection cable or male IEC adapter is required for power-linking features
6
1 Product
st
2 Product
nd
3 Product
rd
Venue Tetra 6 Manual