Safety Instructions - Venue Tetra 6 Manual

SAFETY INSTRUCTIONS

FCC Statement
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
• Please keep this User Manual for future reference.
• Make sure that you are connecting to the proper voltage, and that the line voltage you are connecting to
is not higher than that stated on the decal or rear panel of the fixture.
• This product is intended for indoor use only! To prevent risk of fire or shock, do not expose fixture to rain
or moisture.
• Make sure there are no flammable materials close to the unit while operating.
• The unit must be installed in a location with adequate ventilation, at least 20" (50 cm) from adjacent
surfaces. Be sure that no ventilation slots are blocked.
• Always disconnect from the power source before servicing or replacing the fuse and be sure to replace
with same type fuse.
• Secure fixture to included safety loop using a safety chain.
• Maximum ambient temperature is 104° F (40° C). Do not operate the fixture at temperatures higher
than this.
• In the event of a serious operating problem, stop using the unit immediately. Never try to repair the
unit yourself.
• Never connect the device to a dimmer pack.
• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Never carry the fixture directly from the cord. Always use the hanging/mounting bracket.
• Avoid direct eye exposure to the light source while it is on.
4
Please read these instructions carefully. It includes important
information about the installation, usage and maintenance of
this product.
Venue Tetra 6 Manual