Table of Contents
Advertisement
•
• Built-in automated
• ound activated programs
•
When
controls
remote, Tetra Beam will automatically power up after a few seconds of being plugged in.
STROBE
ON
OFF
1
AUDIO SENSITIVITY
LOW
HIGH
2
1. STROBE SWITCH: Turns the strobe effect on or off
2. AUDIO SENSITIVITY CONTROL: Sets the sound threshold for sound-activated pattern changes when the
MODE switch (#5) is set to the SOUND position. Turn counter-clockwise to decrease sensitivity and clockwise
to increase sensitivity
3. MIC: Internal microphone for the sound-activated pattern changes
4. SPEED CONTROL: Controls the speed of the pattern changes when the MODE switch (#5) is set to the AUTO
position
5. MODE SWITCH: Controls how patterns are changed. In the AUTO position, patterns cycle automatically at a
rate controlled by the SPEED control (#4). In the SOUND position, patterns change based on input from th MIC
(#3) and the threshold set by the AUDIO SENSITIVITY control (#2)
6. POWER IN: Tetra Beam is equipped with a fixed power cable and will power up automatically when
plugged in. Review the safety section (page 5) before connecting the end of this cable to a standard AC power
outlet.
7. FUSE: As a protective measure, Tetra Beam is equipped with a F1AL250V safety fuse. In the case of a mains
power surge, the fuse will blow and protect the internal electronics. To access the fuse, unplug the power
cable from the AC outlet and use a phillips-head screwdriver to open the fuse holder.
8. SAFETY LOOP - When using Tetra Beam in a hanging application a safety chain or cable must be connected
to this loop
moon flower
powers up, it defaults to running the program set by the rear panel
Panel
MODE
AUTO
SOUND
5
3
SPEED
LOW
4
MIC
variable speed
For added convenience when operating without a
TETRA BEAM
HIGH
POWER IN
FUSE
7
6
8
Advertisement
Table of Contents
