Valve To Water Supply Installation - Whitehall BestCare WH3376-WSF Installation, Operation And Maintenance Manual

Instructions for Operation and Care of BestCare Ligature-Resistant Faucets

Valve to Water Supply Installation

!
IMPORTANT
Before making up the supply
connections, the supply lines
must be flushed of all foreign
material such as pipe dope, pipe
chips, solder, sand, etc.
SINGLE TEMPERATURE
METERING VALVE
1/4" OD Supply
Outlet, Provided
B
for -ST Single Temperature
valves, flush supply line.
Connect installer provided
1/2" NPS flex hose to valve.
Valve Assembly Installation:
NOTE: Installation should be in accordance with accepted plumbing practices. Angle
stops are recommended and is the responsibility of the installer
1) Connect hot and cold water to supply valve using 1/2" NPTE connections.
2) Connect outlet of tempering valve to spout(s) using 1/4" OD tubing and adapter.
3) Turn on hot and cold water supplies. If any leaks are observed, hand tighten
connections as necessary to stop leaks before proceeding.
-MXTP VALVE ONLY
4) Turn on fixture and allow water to flow for 2 minutes. Measure water temperature
at outlet. If water is not at desired temperature, adjust as necessary.
8
WHITEHALL MANUFACTURING • P .O. BOX 3527 • City of Industry, CA 91744-0527 U.S.A
Phone (800) 782-7706 • (626) 968-6681 • Fax (626) 855-4862 • Web: www.whitehallmfg.com
A
for MXTP Valve (Hot & Cold), Flush
Supply lines. Connect installer provided
1/2" NPS flex hoses to valve.
HOT & COLD METERING VALVE
1/4" OD Supply
Outlet, Provided
c
for hot & cold temperature valves,
flush supply line. Connect installer
provided 1/2" NPS flex hose to valve.