Prior To Installation - Whitehall BestCare WH3376-WSF Installation, Operation And Maintenance Manual

Instructions for Operation and Care of BestCare Ligature-Resistant Faucets
NOTICE TO INSTALLER:
Check Material for any shortages or damage. Refer to shipping tally sheet
Ÿ
when provides.
Identify all component parts, and hardware: fasteners, brackets, clips, etc.
Ÿ
Study job print carefully. Refer to job print for installation dimensions.
Ÿ

PRIOR TO INSTALLATION:

All Whitehall fixtures are individually factory tested prior to shipping. Valves
Ÿ
are tight and internal piping is free of all foreign material. Do not subject valve
to freezing temperatures. Valve bonnets on brass valve bodies are installed
by the factory with a 35 ft. lbs. torque load. Field installation should be similar.
Note: Tightening beyond 35 ft. lbs. torque can distort valve body. Plastic
valves and fittings should be hand tightened only. Prior to making installation,
all connecting supply lines must be flushed and must be free of all foreign
material - such as pipe dope, pipe chips, solder, sand, etc. If the system is
disinfected using high chlorine concentrates, immediate flushing must take
place. Whitehall will assume no responsibility for leaking valves or clogged
showerheads - due to the presence of foreign material, or distorted valve
bodies - due to excessive torque being applied to the bonnet.
INSTALLATION TOOLS:
Installation tools are regularly furnished with each job when required, i.e., pin
Ÿ
type screws, special anchoring exposed nuts, Shower-Ware and Wash-Ware
Tools. Additional tools may be purchased from Whitehall.
CARE OF STAINLESS STEEL:
Stainless Steel should be kept clean at all times. If maintained, stainless steel
surfaces will retain their new, clean polished appearance indefinitely. To remove
water spots or rust spots, stainless steel cleaner/polish on a cloth is
recommended. IF SPOTS ARE STUBBORN OR IF YOU WISH TO TREAT A
SCRATCH; synthetic, abrasive, general purpose pads such as Scotch-Brite are
recommended. Apply the stainless steel cleaner/polish to the synthetic, abrasive
pad and CAREFULLY rub out spot with cleaner/polish. Be sure to rub in the
direction of the grain. Do not allow steel wool to come in contact with stainless
steel. Steel particles can embed into the stainless steel surface and create rust.
Fixtures with standing pools of water should be routinely flushed at unoccupied
facilities to prevent rusting and build up that can cause damage or corrosion,
such units may not be covered under the warranty.
After installation, these instructions
should be given to maintenance
personnel for future reference.
Notice to Installer:
If there are any questions about this
product, please contact technical
assistance with the job name & Sales
order number.
WHITEHALL MANUFACTURING • P .O. BOX 3527 • City of Industry, CA 91744-0527 U.S.A
Phone (800) 782-7706 • (626) 968-6681 • Fax (626) 855-4862 • Web: www.whitehallmfg.com
JOB NAME:
SALES ORDER #:
®
3