Whirlpool ACS088PR0 Use And Care Manual page 6

Install support platform
1. Slide open one window sash to install support platform.
2. Loosely attach support angle to bottom of support platform
using two " machine screws, flat washers and nuts.
A
B
C
D
A. " machine screws
B. Support plate
C. Flat washer
3. Place support platform against lower window track and firmly
against vertical edge of window frame.
4. Attach support platform to windowsill using two 1" wood
screws.
If required, overcome interference of support platform with
window track or storm windows by securely attaching a shim
strip to the windowsill. Shim strip should be as long as width
of support platform and flush with back edge of sill.
Thickness of shim strip should be controlled by amount of
interference.
A
B
C
A. 1" wood screws
B. Support plate
C. Lower window track
5. Pull support angle against outside of structure. Tighten two
" machine screws on top of support platform.
6. Adjust leveling bolt to level support angle. Tighten leveling
bolt locknut.
NOTE: Air conditioner must be level or tilted back slightly to
facilitate proper condensate disposal.
7. Cut two pieces of seal to height of window opening. Remove
backing and apply to window frame and sliding sash that will
rest against air conditioner cabinet.
6
E
F
D. Nut
E. Support angle
F. Leveling bolt and locknut
D
E
D. Windowsill
E. Shim strip
Install air conditioner in window
1. Slide air conditioner onto support platform. Check to be sure
air conditioner side channel fits securely against vertical edge
of window frame.
NOTE: If air conditioner side channel does not fit securely
against window frame, remove air conditioner and readjust
leveling bolt.
2. Drill two " holes through the window channel frame in
alignment with existing holes in bottom bracket. Install two
" self-tapping screws through these holes.
NOTE: If window channel frame is not tall enough to use
existing holes, drill two new holes off to the side of the
existing holes to attach the air conditioner bottom bracket to
the support platform. Air conditioner should be firmly
anchored to window channel frame or support platform.
A
A. Window channel frame
B. " self-tapping screw
3. Slide inside window sash closed. Check to be sure vertical
edge of inside window sash is pressed firmly against side of
air conditioner cabinet. Cut remaining seal to width of
window opening. Remove backing and apply to top inside
edge of window frame.
4. Install speed clips on top and bottom inside edge of window
to provide locking.
5. Using supplied plastic seal, cut to proper length, insert
between inside window sash and outside window.
A
B
C
A. Speed clip
B. Window channel
C. Plastic seal
6. See "Complete Installation."
B
C
D
C. Bottom bracket
D. " drilled hole