Table of Contents
Advertisement
9. Adjust the leveling bolt until support
angle is level. Tighten the leveling bolt
locknut. This allows air conditioner
to
tilt back slightly for proper condensate
disposal.
NOTE:
Be sure the window track is
securely attached to the building
construction.
Use longer screws into
the subframing if necessary.
Do not drill a hole in the bottom pan.
The air conditioner
is designed to
operate with approximately
W' of
water in the bottom pan.
window frame.
Top retainer
Filler panel
10.
Cut two pieces of adhesive back foam
(Step
17)
(Step 17)
seal
equal to the height of the
Foam seal
window opening. Remove backing
and apply to the vertical inside edges
of the window frame and sliding sash
Foam
that will rest against the air
seal
conditioner.
11.
Replace the sliding sash in the
Channel
9
Advertisement
Table of Contents
