Whirlpool ACS072XG Installation, Use And Care Manual page 8

Installing in a sliding window
NOTE:
This air conditioner must be
installed according to all applicable codes
and ordinances.
4.
5.
6.
7.
1.
Slide open or remove one sliding
window sash from the window frame.
2. Attach support platform to sill plate
with three 3/a"-long self-tapping
screws.
3. Thread locknut to about the middle of
the leveling bolt.
Thread leveling bolt into support angle.
The leveling bolt will be adjusted later.
Loosely attach the support angle to the
bottom
Of the SUDDOrt DkItfOrrt7 USinCl
two 7/l 6"-long &&hi& screws, flat-
washers, and nuts.
3/E"-long
self-tapping
7A 6"~long
screws
Self-tapping screw
Place the support platform assembly
against the lower window track and
firmly against the vertical edge of the
.
window trame.
Attach the support platform assembly
to the window stool using two self-
tapping screws. Tighten screws
securely.
8. Pull the support angle toward the
outside of wall. Tighten 7/l6"-long
machine screws on top of the support
platform.
platform
/
I
assembly
I
Lower window
track
continued on next page
8