User Instructions; Start The Lifter; Charge The Battery - TAWI CR80 User Manual And Spare Parts List

5 User instructions

This chapter describes how to operate the

Start the lifter

Make sure that the wheels rotate smoothly, that the brakes on the rear wheels are functioning proper-
ly and that the battery is charged. Review and perform relevant inspections. See Daily inspections by
operator on page 23, Quarterly inspections by inhouse maintenance on page 24 and Yearly inspections
by TAWI authorised service technician on page 24.
1. Push the joystick up or down to turn on the unit.
» Response: The battery status display is lit up and lift is ready for use.
2. The lifter is now ready for use.
• Only run the lifter when it is completely assembled.
• Check the lifter for safe functionality prior to each use, for instructions, see Inspections on page
23.
• The lifter has overload protection which will prevent tools from being raised when the specified
max load is exceeded. If the overload protection is activated, reduce the load and try again.
• The lifter will automatically turn off when joystick is released. There is an automatic build in on/
off switch in the system which only turns unit on as soon as the joystick is being operated.

Charge the battery

The battery can not be overcharged or charged too often. It is recommended to charge the battery as
soon as it is not in use.
• A damaged power cord could cause electrical shock.
• Never touch any parts inside the battery pack when charging. Touching electrical parts can
cause an electric shock.
16
Manual CR80 GB update 2019.indd 16
CR80.
TAWI
2019-09-11 14:18:44