TAWI CR80 User Manual And Spare Parts List page 6

WARNING
• Before operating a lifter, this manual must be read and understood.
• Always apply brakes to the rear wheels when loading and unloading.
• NEVER exceed the indicated max load capacity on the lifter or on a tool. If a special tool is used,
there might be a separate max load capacity indicated on the tool, make sure to always comply to
both.
• Make sure to load according to the load diagrams including y-distances. See Labels on TAWI CR80 on
page 09 and Loading on page 14.
• Make sure loads are distributed evenly on the platform and always load according to load diagram.
• The operator's position should always be behind the lifter when it is used, also when using the hand
control!
• Stay clear of the area underneath a tool at all times.
• Stay clear of moving parts.
• During all service and maintenance, lay the lifter down on the floor (on its back).
• In order to deal with the lifter's cables and wiring, a good knowledge of electricity and TAWI electri-
cal schedules of the lifters is required. Faults can cause damage to people and property.
• NEVER climb on the lifter.
• NEVER stand on the housing or any other part of the lifter.
Caution
• The lifters are made for indoor use on a smooth, even floor/surface. Max allowed inclination is 4%.
• The recommended temperature range for the lifters is 10 - 50 degrees Celsius (50 - 122 degrees
Fahrenheit). The lifting performance may vary when the temperature deviates from 20 degrees
Celsius
(68 degrees Fahrenheit).
• Make sure there is good lighting in areas where the lifter is operated.
• Use caution when passing over thresholds, floor drains, hoses or cables.
• Lifter can be washed with pressure washers. The CR80 have IP65 rating.
• Recharge the battery in a designated dry area.
• Any part of this lifter or accessories that show signs of wear or other damage must be replaced
immediately. The lifter must not be used before the damaged part is replaced.
• Do not use the lifter while it is plugged into an outlet.
• Only run the lifter when it is completely assembled.
• Wear steel toe shoes with good grip when operating the lifter.
• Never manually move the tool past the top switch.
• There is always one top switch and one bottom switch assembled on the lifter. NEVER move the top
or bottom switches.
6
Manual CR80 GB update 2019.indd 6 2019-09-11 14:18:42