Siemens ULTRAMAT 6 Manual page 95

Status coding for ULTRAMAT/OXYMAT/CALOMAT:
Dec Hex
11 0B Component missing
12 0C Device error
31 1F Out of order (equivalent value,
last valid value, through connect
value)
Dec Hex
64 40 Function control
71 47 Measured value is bad,
last valid value
75 4B Measured value is bad,
equivalent value
79 4F After switching on the power,
initial value
80 50 Measured value is out of range
Dec Hex
128 80 o.k., normal operation
132 84 Active block alarm, parameter
has been changed
137 89 Lower warning limit exceeded
138 8A Upper warning limit exceeded
141 8D Lower alarm limit exceeded
142 8E Upper alarm limit exceeded
164 A4 Maintenance request
ULTRAMAT 6 / OXYMAT 6 / CALOMAT 6 / ULTRAMAT 23 / OXYMAT 61
Schnittstelle PROFIBUS DP / PA Interface
A5E00054148-03
Status coding for "bad quality"
Cause
Change configuration, install analyser including this
component
Check with SIMATIC PDM / change analyzer
Depending on the paramterization. Switch in mode AUTO
Status coding for "uncertain quality"
Cause
Warm up, AUTOCAL, in situ service
Check with SIMATIC PDM / change analyzer
Check with SIMATIC PDM / change analyzer
Reject the measured value
Check with SIMATIC PDM / ambient temperature too high
Status coding for "good quality"
Cause
You can evaluate the measured values
Disappears after 10 seconds
user programm
user programm
user programm
user programm
Check with SIMATIC PDM
Remedy
Remedy
Remedy
95