Advertisement
Quick Links
Advertisement
Related Manuals for Majacraft Pioneer X
Summary of Contents for Majacraft Pioneer X
- Page 1 Your new Pioneer spinning wheel majacraft all you need to spin your dreams... majacraft...
- Page 2 Thank you for choosing Majacraft, it is your belief in us that drives our innovation and creativity in building captivating tools for you.
- Page 3 Assembling a Majacraft Pioneer These instructions demonstrate how to assemble your Majacraft Pioneer spinning wheel. 1. Prepare the components We recommend that you find a clear work area where you can lay out all the components for working on them.
- Page 4 JCB bolts into place but do not tighten them fully. When they all located correctly then tighten the JCB bolts securing the stem onto the base assembly. 3. Attach drive wheel to stem Required: 5mm allen key (in the hardware bag) Base/Stem assembly Drive Wheel majacraft...
- Page 5 When located correctly, use the 5mm allen key to screw the axle bolt into the stem. Tighten it firmly. The drive wheel is now attached to the base/stem assembly. 4. Pulley on to Flyer Shaft Required: Pulley 2mm allen key (in the hardware bag) majacraft...
- Page 6 5. Drive Band Required: 1 - Green drive band (in the hardware bag) The green drive band goes on the groove on the drive wheel and then through one of the grooves on the pulley. majacraft...
-
Page 7: Crank Assembly
Similar to the base/stem assembly process, do not fully tighten the centre bolt until you have aligned and started screwing in the two bolts on the sides. When the three bolts are all in place, you can finish tightening them up. majacraft... - Page 8 When the rod end is aligned correctly - parallel with the face of the drive wheel - screw the 25mm screw into place. The screw should only be tightened until the head just touches the side of the pedal. DO NOT OVERTIGHTEN! majacraft...
- Page 9 8. Bobbin, Flyer and Scotch Tension Required: 1 - Bobbin 1 - Flyer If you have some petroleum jelly or vaseline, rub a small smear onto the flyer shaft. majacraft...
- Page 10 When looking at the wheel from the front (the pedal side), loop the brake tension band over the top of the bobbin from the right hand side over to the left hand side. Refer to the Majacraft Spinning Manual for a more thorough description on setting the tension.
- Page 11 Pioneer looking great into the future. Your Majacraft Pioneer is now assembled and you are ready to start on a new spinning adventure! From the team at Majacraft, we wish you great spinning in the future.
Need help?
Do you have a question about the Pioneer X and is the answer not in the manual?
Questions and answers