Linhai M565Li Owner's Manual page 83

M565Li OWNER'S/OPERATOR'S MANUAL
16. MAINTENCE
Oil may be hot. Do not allow hot oil to come into contact with skin as
severe burns may result
1. Place ATV on a level surface;
2. Run engine two or three minutes until warm, Stop engine;
3. Clean area around drain plug;
4. Place a drain pan beneath engine crankcase and remove drain plug;
5. Allow oil to drain completely;
6. Reinstall drain plug and torque to 25 Nm.
Rear Gear Case Lubrication (T3b models)
Be sure no foreign material enters the Gear / Differential case.
With the ATV on a level surface, remove fill plug and visually inspect the
oil level through the fill hole. Oil should be kept even with the center of
the drill point approximately below the top of the fill hole.
NOTE:
Do not add oil to the bottom of the fill plug threads.
The correct gear case oil to use is SAE GL-5 85W/90 Hypoid Oil.
Recommended Rear Gear Case oil:
MAXIMA HYPOID GEAR LUBE PREMIUM 80W90 - GL5
83